Power M2 Door

PRESSURE RESISTANCE

It is resistant to 17 Kg / m2 pressure. (This pressure corresponds to 60 km / hour wind speed.)

OPENING SPEED

2.4 mt / sec.

CLOSING SPEED

.2 mt / sec.

OPTIONAL SPEED

Up to a speed of 2.4 mt / sec up to 20 m2, 2 mt / sec between 20 - 24 m2 and 1.6 mt / sec on 24 m2 if desired. Speed ​​can be increased.

MODE OF OPERATION

Gear drive, no lining.

STITCHES

Galvanized, U profile (80 x 40 x 3mm)

DRUM

It is made of 102 X 2mm diameter steel material. PVC curtain is never visible because it wraps around the drum. (Even with the door closed.)

POLYETHYLENE SIDE STICKERS

(PE - UHMW 1000)

They are spring struts measuring 23 x 40mm.

ENHANCED PVC curtains E

900 gr / m2 sealed

STANDARD COLORS

Yellow (RAL 1003)
Gray (RAL 7035)
Blue (RAL 5002)
Red (RAL 3000)
Green (RAL 6005)
White (RAL 9010)
Orange (RAL 2004)
Black (RAL 9005)

In addition, curtain reinforcement beams in black color (16 x 12.5mm) are used as standard in all colors .

ENGINE

It is a motor system without brake and has 4 poles. Motor speed frequency

It is adjusted by an inverter. 0.75 Kw motor is used up to 14 m2 and 1.5 Kw motor is used for larger doors. Motor voltage 3 x 230/400 V. Protection class IP 65.

GEAR BOX

It works with a large bevel gear system coupled with a worm gear . Its size is 50 and the reduction ratio is 1/7. (For 0.75 mo tor)

CONTROL BOARD

It is produced according to DYNACO Standards and in the system

magnetothermic circuit breaker is used. 24V AC transformer is used. There is an adjustable time for shutdown, a button to reset the system in case of power cuts or emergency situations. Protection class IP 65

DOOR STOP

DYNACO doors also use an encoder switch system instead of mechanical switches that are used in other doors in the market and cause problems over time . 

LIMIT SWITCHLER

The transmitter of the wireless detector system is located on the lower skirt of the door and its receiver is inside the control unit. When this sensor encounters any obstacle under the door, the transmitter switches to standby mode and immediately sends a signal to the receiver, allowing the door to be opened back. 

DETECTOR (WDD)

Depending on the door type, single phase 220 - 240V or 3 phase 380 - 400Venergy can be used. Gate 50 - 60 Hz. It works on its frequency. When installing energy for doors, 16 A fuse must be used for 0.75 Kw motor, 25 A fuse for 1.5 Kw motor.

ENERGY

• Doors according to EN 13241 - 1 standard;

Water permeability Test result according to EN 12425 standard : class 1             

Wind load test result according to EN 12424 standard : class 3                

Safe opening Test result according to EN 12453 standard : pass             

Mechanical resistance Test result according to EN 12604 standard : pass     

Thermal conductivity Test result according to EN 12428 standard : 6.02w / m 2 k                   

• The 10000 cycle trouble-free operation performance of the door has been tested and documented according to EN 12604 standard.